Preparing and cleaning the substrate
- Clean the substrate carefully and make sure to remove dust and dirt from the surface.
- Do not apply SAFE MARBLE to damp or wet substrates. The product must be applied to the driest possible surface.
- Apply SAFE MARBLE during the coolest hours of the day.
- Do not treat with SAFE MARBLE if the floor is directly exposed to sunlight.
- Apply SAFE MARBLE to substrates with a surface temperature of +5 to +40 °C.
- If present, protect adjacent surfaces to which you do not want to apply the product.
- Remove from the surface to be treated any previous treatments, such as waxes and resins. To make the treatment as effective as possible, it is important that SAFE MARBLE comes into direct contact with the surface of the substrate you want to make anti-slip.
Test to determine the contact time
Given the very wide range of materials on which anti-slip treatment may be needed, and which differ from one another in composition, resistance and surface hardness, to achieve the optimal result in terms of the degree of slip resistance without changing the original appearance of the substrate, a preliminary test must be carried out to determine the most suitable contact time between the surface and SAFE MARBLE.
The test must be carried out before applying the treatment to the whole surface, on a part of the material that has not been laid, or in a part that is out of sight.
In general, the most suitable time intervals are as follows:
- Limestone, soft marbles and soft limestone surfaces 10–20 minutes
- Hard and compact limestone surfaces 15–30 minutes
If the result is still not sufficient even after 30 minutes of contact, we recommend continuing in steps of about 10 minutes until the required degree is reached.
The times given are based on our extensive technical and operational experience, but they should be regarded as purely indicative and used as a guide for the preliminary test carried out on the surface.
The degree of slip resistance achieved in the preliminary test must be assessed after the surface has been rinsed thoroughly and generously with water once the application of the product is finished, so that any residues do not distort the reading of the result actually achieved.
The assessment of the result achieved must be carried out following these simple but essential instructions
- Carry out the assessment on a wet floor
- Assess by hand, rubbing the fingers of your hand over the surface and applying considerable pressure to simulate the weight of a person walking
- Compare the treated part with the untreated one in order to better perceive the different degree of grip created
Application
Always test the product on a part of the surface that is out of sight, or on a tile that has not been laid, before applying it, to assess its suitability for the intended use.
- The product is ready to use.
- Apply a generous and even film of the product with the tool you prefer, making sure that an even layer covers the entire treated surface.
- Leave the product to act for the time determined in the preliminary test. During this time it is important that the floor surface stays evenly wet and covered with a layer of the product.
- If necessary, spread SAFE MARBLE again and apply an additional amount. Areas without the product during treatment may cause an uneven final appearance and an uneven degree of slip resistance.
- Once the time determined in the test has elapsed, remove the excess, preferably with a wet vacuum, and immediately afterwards rinse thoroughly and abundantly with clean water.
- Removal of residues and rinsing with water must take into account the actual contact times between the product and the surface. Therefore begin removal at the point where you started applying SAFE MARBLE, and make sure you remove it from the treated area in the same time it took to apply it. This way the product acts on the whole surface for the same length of time.
- To make application easier, for large areas we recommend working section by section. Choose the size of the sections according to the set contact time: short contact times call for small sections, with longer times larger sections can be defined.
Opening to traffic
A surface treated with SAFE MARBLE can be opened to traffic once the product has been completely removed.