Before applying the product, always carry out a preliminary test on a part of the surface that is not exposed to view, to assess its suitability for the intended use
Preparing and cleaning the substrate
- Clean the substrate carefully and make sure to remove dust and dirt from the surface.
- Wait until the treated surface is dry.
- Do not carry out the treatment with SAFE FLOOR if the floor is directly exposed to sunlight.
- If present, protect adjacent surfaces to which you do not want to apply the product.
- Apply the product to substrates with a surface temperature from +5 to +40 °C
- Remove any previous treatments from the surface you want to treat. For the treatment to be as effective as possible, it is important that SAFE FLOOR comes into direct contact with the surface of the substrate that you want to make anti-slip
Application
Given the very wide range of materials on which anti-slip treatment may need to be carried out, which differ from one another in composition, resistance and surface hardness, in order to achieve the optimal result in terms of degree of slip resistance without changing the original appearance of the substrate, a preliminary test must be carried out, the aim of which is to determine the most suitable contact time between the surface and SAFE FLOOR.
The test must be carried out before applying the treatment to the whole surface, on a part of the material that has not been laid, or in a part that is out of sight.
In general, the most suitable time intervals are between 15 and 60 minutes; however, the times should be regarded as purely indicative and used merely as a guide for the preliminary test carried out on the surface.
The degree of slip resistance achieved in the preliminary test must be assessed after the surface has been rinsed thoroughly and generously with water once the application of the product is finished, so that any residues do not distort the reading of the result actually achieved.
The assessment of the result achieved must be carried out following these simple but essential instructions
- Carry out the assessment on a wet floor
- Assess by hand, rubbing the fingers of your hand over the surface and applying considerable pressure to simulate the weight of a person walking
- Compare the treated part with the untreated one in order to better perceive the different degree of grip created
The product is used neat, without dilution. Apply a generous and even film of the product with the tool you prefer, making sure to create an even layer covering the whole surface being treated.
Leave the product to act for the time determined in the preliminary test. During this time it is important that the floor surface remains evenly wet and covered with a layer of the product at all times. Therefore, if necessary, spread SAFE FLOOR again and apply a further amount.
After the time determined in the test has elapsed, remove the excess, if possible with a wet vacuum cleaner or absorbent paper or rags, and immediately afterwards rinse thoroughly and generously with clean water.
Opening to traffic
After the residues have been thoroughly removed and the surface rinsed with water, the surface can be opened to foot traffic.