Before applying the product, always carry out a preliminary test in a place that is not exposed to view, to assess its suitability for the intended use.
Preparing and cleaning the substrate
- Clean the substrate carefully and make sure to remove dust and dirt from the surface.
- If present, protect adjacent surfaces to which you do not want to apply the product.
- Apply the product to substrates with a surface temperature from +5 to +40 °C.
- If there is a layer of wax or a previously applied treatment on the surface being treated, remove it with SOLVENT STRIPPER or WAX REMOVER.
Application
The product is used undiluted. Apply the product directly onto the stain you want to remove. Use a brush, a spatula or, if it is easy to do, pour the product directly onto the surface and leave a generous layer of product that covers it completely. When applying to particularly large areas, for example when removing mould and algae from paving, the product can be spread and worked in with a single-disc machine, a brush or other tools suitable for this purpose.
Leave the product to act on the surface until the stain being treated has been completely drawn out. The time required depends on the intensity of the stain, its depth and tenacity, and the time that has passed since it appeared.
Although every stain has different characteristics that may require a specific and different time, the contact times needed to lift stains can generally be summarised as follows:
- Stains from coffee, wine, tea, coca-cola, tomatoes, food and drinks in general: 30 minutes to 2 hours.
- Marker and ink stains: 30 minutes to 3 hours
- Mould, algae, plant growth and residues in general: 15 minutes to 1 hour
After the stated time has passed, remove the product and its residues. To remove COLOURED STAIN REMOVER on small areas, paper or absorbent cloths can be used; soak up or remove the residues until they are completely gone. Wipe with a slightly damp cloth and wait for the surface to dry completely before assessing the result of the stain removal. On medium or large areas, remove the residues with a brush and absorbent rags or a slightly damp mop until the excess is completely removed. Wipe the surface with a slightly damp cloth or mop, wait for it to dry completely and then assess the result achieved.
If the result achieved is only partially satisfactory, it is recommended to repeat the application of the product in the same way or to consider the need for preliminary sanding. If the stain is of a mixed nature, using a different type of stain remover may also be effective.
When working on particularly absorbent surfaces, for example raw natural stone or cotto, the surface to be treated must be slightly dampened with water before applying the product, so that the material does not absorb too much of it.
Opening to traffic
After rinsing the surface with water, wait for the floor to dry completely before opening it to foot traffic again.